{"id":3806,"date":"2026-09-29T05:43:56","date_gmt":"2026-09-29T05:43:56","guid":{"rendered":"https:\/\/shop.autoboss.com\/?post_type=product&#038;p=3806"},"modified":"2026-10-09T08:20:31","modified_gmt":"2026-10-09T08:20:31","slug":"autool-ct450-ultrasonic-fuel-injector-cleaner","status":"publish","type":"product","link":"https:\/\/autoboss.com\/es\/product\/autool-ct450-ultrasonic-fuel-injector-cleaner\/","title":{"rendered":"AUTOOL CT450 6-Cylinder Heated GDI\/EFI\/FSI Fuel Injector Cleaner and Tester"},"content":{"rendered":"<div class=\"abd-pd\" data-abd-version=\"1\">\n<header class=\"abd-hero\">\n<h3>Heated Ultrasonic Cleaning and Six-Position Injector Testing<\/h3>\n<p class=\"abd-lead\">Clean compatible gasoline, EFI, FSI and selected GDI injectors in a heated ultrasonic tank, then compare up to six injectors for spray, leakage, collected volume and pulse response at 12 V, 70 V or 120 V drive. Testing runs at low bench pressure, not original GDI pressure.<\/p>\n<ul class=\"abd-facts\">\n<li>6 Injector Stations<\/li>\n<li>12 \/ 70 \/ 120 V Drive<\/li>\n<li>Heated to 50 \u00b0C<\/li>\n<li>28 kHz Ultrasonic Tank<\/li>\n<li>3 Cleaning + 10 Test Functions<\/li>\n<\/ul>\n<\/header>\n<section class=\"abd-sec\" id=\"abd-features\">\n<h4>Key Features<\/h4>\n<ol class=\"abd-features\">\n<li>\n<h5>Heated Ultrasonic Cleaning<\/h5>\n<p>Ultrasonic energy combined with thermostatic heating, used when the cleaning chemistry, injector material and procedure permit heat.<\/p>\n<\/li>\n<li>\n<h5>Selectable Injector Drive<\/h5>\n<p>Choose 12 V, 70 V or 120 V to match supported injectors, using verified part-number and manufacturer information.<\/p>\n<\/li>\n<li>\n<h5>Side-by-Side Comparison<\/h5>\n<p>Observe up to six injectors under one controlled setup for relative spray and collected-volume differences.<\/p>\n<\/li>\n<li>\n<h5>Pulse-Injection Observation<\/h5>\n<p>Run intermittent injection at supported pulse settings to compare response and spray behavior.<\/p>\n<\/li>\n<li>\n<h5>Leak, Spray and Volume Checks<\/h5>\n<p>Glass tubes and an illuminated test area show comparative leakage, spray shape and volume once fixture sealing is checked.<\/p>\n<\/li>\n<li>\n<h5>Reverse Flushing<\/h5>\n<p>Available for injector designs where the feed direction and manufacturer procedure allow reverse flow.<\/p>\n<\/li>\n<li>\n<h5>Practical Workshop Controls<\/h5>\n<p>Fluid-level indicator, drain valves, glass-tube lighting, foldable grip and side handle.<\/p>\n<\/li>\n<li>\n<h5>Accessory Storage Drawer<\/h5>\n<p>Keeps adapters, plugs, cables, seals and fittings close to the bench.<\/p>\n<\/li>\n<\/ol>\n<\/section>\n<section class=\"abd-sec\" id=\"abd-specs\">\n<h4>More Specifications<\/h4>\n<div class=\"abd-table-wrap\">\n<table class=\"abd-table abd-specs\">\n<tbody>\n<tr>\n<th scope=\"row\">Diesel injectors<\/th>\n<td>Cleaning only when the approved procedure permits; no testing<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Display<\/th>\n<td>LCD display with pressure gauge<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Cleaning tank<\/th>\n<td>Integrated (not removable), with cleaning-fluid recovery valve<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Test liquid level gauge<\/th>\n<td>Yes<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n<\/div>\n<\/section>\n<section class=\"abd-sec\" id=\"abd-compare\">\n<h4>Model Comparison<\/h4>\n<div class=\"abd-table-wrap\">\n<table class=\"abd-table abd-compare\">\n<thead>\n<tr>\n<th scope=\"col\"><\/th>\n<th scope=\"col\">CT400<\/th>\n<th scope=\"col\" class=\"is-current\">CT450<\/th>\n<th scope=\"col\">CT500<\/th>\n<\/tr>\n<\/thead>\n<tbody>\n<tr>\n<th scope=\"row\">Cleaning fluid heating<\/th>\n<td>No<\/td>\n<td class=\"is-current\">Up to 50 \u00b0C<\/td>\n<td>No<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Testing functions<\/th>\n<td>9<\/td>\n<td class=\"is-current\">10<\/td>\n<td>12<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Pulse injection test<\/th>\n<td>No<\/td>\n<td class=\"is-current\">Yes<\/td>\n<td>Yes, plus wide-pulse and continuous injection tests<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Pulse settings<\/th>\n<td>0-20 ms<\/td>\n<td class=\"is-current\">0-20 ms<\/td>\n<td>0-40 ms, 0.1 ms step<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Language settings<\/th>\n<td>No<\/td>\n<td class=\"is-current\">No<\/td>\n<td>Chinese, English<\/td>\n<\/tr>\n<tr>\n<th scope=\"row\">Oil baffle<\/th>\n<td>No<\/td>\n<td class=\"is-current\">No<\/td>\n<td>Yes<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n<\/div>\n<\/section>\n<section class=\"abd-sec\" id=\"abd-box\">\n<h4>What&#8217;s in the Box<\/h4>\n<ul class=\"abd-box\">\n<li>CT450 main unit<\/li>\n<li>Injector adapters, including types for supported BMW injectors<\/li>\n<li>Glass measuring cylinders<\/li>\n<li>Injector signal cables and connector parts<\/li>\n<li>O-rings, plugs, caps and fittings<\/li>\n<li>Funnel, drain-valve parts and metal tray cover<\/li>\n<li>Power cable<\/li>\n<li>User manual<\/li>\n<\/ul>\n<figure class=\"abd-fig\"><img decoding=\"async\" src=\"https:\/\/autoboss.com\/wp-content\/uploads\/autool-catalog\/media\/eb2dd52fa11c4a5232f118e3.webp\" alt=\"AUTOOL CT450 injector cleaner with adapter sets, rods, funnel, drain valve, tray cover, O-rings, caps, signal cables, power cable, fuel rail and user manual\" width=\"1200\" height=\"1200\" loading=\"lazy\"><figcaption>CT450 package contents; the regional power version follows the current package.<\/figcaption><\/figure>\n<\/section>\n<section class=\"abd-sec\" id=\"abd-use\">\n<h4>How to Use<\/h4>\n<ol class=\"abd-steps\">\n<li><b>Identify the injector<\/b><span>Record make and part number, and confirm drive, feed direction, adapter, seals and temperature limit.<\/span><\/li>\n<li><b>Select adapter and voltage<\/b><span>Choose the connector, rail adapter and 12 V, 70 V or 120 V setting from verified data; stop if the drive is unknown.<\/span><\/li>\n<li><b>Fill and set heat<\/b><span>Fill the tank to the manual&#8217;s level with approved cleaning fluid and set a permitted temperature.<\/span><\/li>\n<li><b>Run the cleaning cycle<\/b><span>Secure and connect the injectors, then run the ultrasonic and pulse-cleaning cycle.<\/span><\/li>\n<li><b>Mount and seal<\/b><span>Install injectors with the correct fittings and new seals where required, and plug every unused position.<\/span><\/li>\n<li><b>Configure the test<\/b><span>Add approved test fluid and set voltage, pressure, pulse, time and test mode.<\/span><\/li>\n<li><b>Test, compare and drain<\/b><span>Run checks under identical conditions, swap channels if needed, retest after cleaning and drain each fluid through its own path.<\/span><\/li>\n<\/ol>\n<p class=\"abd-note\">Cleaning, testing, voltage selection and troubleshooting: <a href=\"https:\/\/autoboss.com\/wp-content\/uploads\/autool-catalog\/media\/a65152f5d9eca4800e5bb3ec.pdf\" target=\"_blank\" rel=\"noopener\">CT450 user manual (PDF)<\/a>.<\/p>\n<\/section>\n<section class=\"abd-sec\" id=\"abd-notes\">\n<h4>Good to Know<\/h4>\n<div class=\"abd-notes\">\n<div class=\"abd-note-group is-caution\">\n<h5><span class=\"abd-tag\">Caution<\/span><\/h5>\n<ul>\n<li>Never run the ultrasonic tank dry; doing so may damage the ultrasonic system.<\/li>\n<li>Keep cleaning fluid out of the test circuit. Never use gasoline or a corrosive cleaner as test fluid.<\/li>\n<li>Heat only when the injector, seals and cleaning chemistry are compatible with the chosen temperature.<\/li>\n<li>CT450 is not a high-pressure GDI characterization, coding or calibration machine.<\/li>\n<\/ul>\n<\/div>\n<div class=\"abd-note-group is-care\">\n<h5><span class=\"abd-tag\">Care<\/span><\/h5>\n<ul>\n<li>Before long storage, recover or drain the test fluid through the specified path.<\/li>\n<li>Before judging an injector, rule out adapter, seal and channel leakage and repeat the test under the same settings.<\/li>\n<\/ul>\n<\/div>\n<\/div>\n<\/section>\n<\/div>","protected":false},"excerpt":{"rendered":"<ul>\n<li><strong>GDI \/ EFI \/ FSI Drive:<\/strong> Select the matched 12 V, 70 V, or 120 V drive for compatible standard gasoline, EFI, FSI, and selected GDI injectors.<\/li>\n<li><strong>Six 110 mL Cylinders:<\/strong> Compare spray appearance and collected volume across up to six compatible injectors under one controlled setup.<\/li>\n<li><strong>28 kHz Heating to 50\u00b0C:<\/strong> Clean compatible injectors with 28 kHz ultrasound and controlled heating up to 50\u00b0C.<\/li>\n<li><strong>13 Cleaning\/Test Functions:<\/strong> Use 3 cleaning and 10 testing functions for heated ultrasonic cleaning, reverse flushing, leakage, spray, preset cycles and pulse-injection observation.<\/li>\n<li><strong>Pulse-Injection Observation:<\/strong> Run intermittent injection at supported pulse settings to compare relative response and atomization behavior.<\/li>\n<\/ul>","protected":false},"featured_media":12667,"comment_status":"open","ping_status":"closed","template":"","meta":{"_gspb_post_css":""},"product_brand":[128],"product_cat":[62,85],"product_tag":[],"class_list":["post-3806","product","type-product","status-publish","has-post-thumbnail","product_brand-autool","product_cat-best-selling-products","product_cat-fuel-injector-cleaner-tester","first","instock","featured","shipping-taxable","purchasable","product-type-variable"],"_links":{"self":[{"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/product\/3806","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/types\/product"}],"replies":[{"embeddable":true,"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/comments?post=3806"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/media\/12667"}],"wp:attachment":[{"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/media?parent=3806"}],"wp:term":[{"taxonomy":"product_brand","embeddable":true,"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/product_brand?post=3806"},{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/product_cat?post=3806"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/autoboss.com\/es\/wp-json\/wp\/v2\/product_tag?post=3806"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}