With the rise of automobile use, more and more cars will now encounter a variety of difficult problems, you repair engineers need to gradually rise in the knowledge base of the vehicle, in order to help you enhance the summary of the possible problems of the model. This article will tell you how to repair the 2008 lexus es 350 headlights model, the use of blinking hazard lights can not be turned off after the phenomenon has been flashing.
Fault phenomenon
Hazard lamp keeps flashing, switch on and off the blinking hazard lights during the test, the state of the hazard lamp remains unchanged, the switch is invalid.
The problem is the same as in the video above, the hazard lights keep flashing and won't turn off.
After removing the part and unplugging it, the emergency lights car will no longer flash.
Test Methods
1. Check the circuit diagram to make sure that the control wire is located at pin 8 of the plug in the diagram.
2. Locate pin 8 of the plug as shown in the figure below.
3. Check the data, the voltage is 7V when the emergency lights car switch is not pressed down, and 0V when it is pressed down.
4. Remove the panel and measure the switch. There is still a 2.2k resistance to ground when not pressed down, proving that there is a problem inside the switch.
5. Remove the parts for repair and just clean the inside of the switch.
6. After the repair is complete, the parts are put back into the vehicle to test whether the hazard lights work properly.
Above is the content of toyota es350 blinking hazard lights Cannot Be Turned Off Repair, more models please see the next blog, welcome to subscribe as well as in the comment section to discuss more models of repair information, if you still have questions about the repair process are also welcome to leave a message in the comment section, you can contact me through the official email or WhatsApp.
Preview repair model: BMW X5 active steering control failure repair
Share:
Mercedes-Benz S65 Engine Oil and Oil Filter Replacement
Volkswagen Unable to start (gauge shows put selector lever in P/N position!) Failure Case