A 4,500 kg Clear-Floor Lift in Standard or Wide Column Spacing
Choose the ATL-4.5D for a standard bay or the ATL-4.5DW for wider column clearance; both use dual-cylinder direct-drive hydraulics with wire-rope synchronization and release both safety locks from one side. A level concrete foundation and adequate ceiling height are required.
- 4,500 kg capaciteit
- 95 mm minimale hoogte
- Standaard / brede indeling
- Dubbele ontgrendeling aan รฉรฉn kant
- Armen voor laag chassis
Key Features
-
Gesynchroniseerde hefbrug met directe aandrijving
Two hydraulic cylinders push directly while a wire-rope balance system keeps both carriages rising evenly, with no lifting chains.
-
Dubbele ontgrendeling aan รฉรฉn zijde
A single control side releases the locks on both columns at once, so the vehicle cannot tilt from one side unlocking while the other stays locked.
-
Veiligheidsvergrendelingen met haak
The hook design helps prevent slippage caused by slider wear, and gear-type arm locks hold the support arms in position.
-
Armen voor lage voertuigen
Reinforced second and third support arms suit sports cars and ultra-low chassis designs.
-
Precisiehydrauliek
Laser-cut steel plates, CNC-machined cylinders with roller-burnished barrels, and Japanese seals for accurate fit and reliable sealing.
-
Slijtage- en corrosiebestendigheid
High-molecular wear-resistant sliders reduce friction, and a shot-blasted, high-temperature spray-coated finish resists corrosion.
Meer specificaties
| EU-teststandaard | 150% statische test, 115% dynamische test |
|---|---|
| Carriage | Sterke hefslede van 1.95 m |
| Lift pads | Three-stage screw pads with height extension sleeve |
| Steel plate | 16 mm verdikte, massieve staalplaat |
How to Use
- Controleer de geschiktheid van de locatieConfirm the lift drawing, concrete strength and thickness, anchors, ceiling and door clearance, power and approach space.
- Inspecteer vรณรณr gebruikCheck anchors, columns, arms, pads, hoses, cables, cylinders, locks and synchronization parts.
- Het voertuig positionerenCenter it between the columns with doors, tires and bodywork clear of moving parts.
- Stel de hefpunten inPlace arms and pads at the manufacturer’s approved lift points for the actual wheelbase and load.
- Hef op en controleerLift just enough to take the load, verify all contact points and balance, then continue while watching both sides.
- Vergrendel vรณรณr het werkLower onto the mechanical locks and confirm both sides are engaged before anyone goes underneath.
- Maak vrij en laat zakkenRemove tools and people, release the locks, lower under control and check the lift after the vehicle exits.
Good to Know
Let op
- Professional installation is recommended: anchoring, leveling, electrical connection, hydraulic setup, balance adjustment and safety checks must be done correctly.
- Confirm workshop ceiling height and overhead clearance against the lift’s overall height before ordering.
- Confirm the voltage option before ordering. Electronic unlocking, where required, may cost extra.
- Infrared, foot, arm or other optional protection is present only if included in the ordered configuration.
- Stop using the lift if hoses, cylinders, cables, seals, anchors or synchronization show damage, leakage or abnormal movement.
English 
Deutsch 
Espaรฑol 
Nederlands 
Franรงais 