Hauptmerkmale

1. Synchronized Direct-Drive Lift

   Two hydraulic cylinders push directly while a wire-rope balance system keeps both carriages rising evenly, with no lifting chains.

2. One-Side Dual Unlocking

   A single control side releases the locks on both columns at once, so the vehicle cannot tilt from one side unlocking while the other stays locked.

3. Hook-Type Safety Locks

   The hook design helps prevent slippage caused by slider wear, and gear-type arm locks hold the support arms in position.

4. Arms for Low Vehicles

   Reinforced second and third support arms suit sports cars and ultra-low chassis designs.

5. Precision Hydraulics

   Laser-cut steel plates, CNC-machined cylinders with roller-burnished barrels, and Japanese seals for accurate fit and reliable sealing.

6. Wear and Corrosion Resistance

   High-molecular wear-resistant sliders reduce friction, and a shot-blasted, high-temperature spray-coated finish resists corrosion.

More Specifications

Anwendung

1. Qualify the siteConfirm the lift drawing, concrete strength and thickness, anchors, ceiling and door clearance, power and approach space.
2. Inspect before useCheck anchors, columns, arms, pads, hoses, cables, cylinders, locks and synchronization parts.
3. Position the vehicleCenter it between the columns with doors, tires and bodywork clear of moving parts.
4. Set pickup pointsPlace arms and pads at the manufacturer’s approved lift points for the actual wheelbase and load.
5. Raise and checkLift just enough to take the load, verify all contact points and balance, then continue while watching both sides.
6. Lock before workingLower onto the mechanical locks and confirm both sides are engaged before anyone goes underneath.
7. Clear and lowerRemove tools and people, release the locks, lower under control and check the lift after the vehicle exits.

Good to Know