Voeding, massa en kortsluitingen vanaf de accu opsporen
The BT160 is a powered circuit probe for 6–24 V DC vehicle systems: it shows polarity and continuity by LED and buzzer, checks grounds and diodes, and can feed power or ground to a selected component. It has no screen and does not read exact voltage values.
- 6–24 V DC
- 4 m geïntegreerde kabel
- Overbelastingsuitschakeling bij 10 A
- Rode / groene LED + zoemer
Key Features
-
Polarity Test
Touch an unknown contact: red LED for positive, green LED for negative.
-
Continuïteit en onderbroken circuit
With the auxiliary ground lead on one end and the probe on the other, check wires, fuses, relays and switches for an open path.
-
Diodes en massa controleren
Test a diode assembly, or confirm a component’s negative ground with green LED and buzzer feedback.
-
Kortsluiting opsporen
Remove the blown fuse, start at the fuse socket and follow the harness section by section to find the shorted side.
-
Componentactivering
The rocker switch applies positive or negative output to a component on the vehicle or on the bench.
-
Lange overbruggingskabel
The black clip and auxiliary ground lead are linked through the unit, so it can serve as a long jumper test lead for front-to-rear harness work.
Modelvergelijking
| BT160 | BT210 | BT250 | BT280 | |
|---|---|---|---|---|
| Bedrijfsspanning | 6–24 V | 9–30 V | 9–30 V | 9–30 V |
| AC / DC-spanning uitlezen | No | 9–30 V | 0–65 V | 0.1–100 V |
| Resistance | No | No | 0–200 kΩ | 1–200 kΩ |
| Power cable | 4 m | 1.1 m | 1.5 m | 6 m |
| Temperatuurtest / LED-lamp | Nee / Nee | Yes / Yes | Nee / Ja | Nee / Ja |
| Oscilloscoop en multimeter | No | No | No | Ja |
Inhoud van de doos
- BT160 main unit with integrated 4 m lead and red/black battery clips
- Hulpmassaklem
- User manual
How to Use
- Sluit aan op de accuUnroll the lead; red clip to battery positive, black clip to negative.
- Self-testPress the switch and confirm the LEDs: red for positive, green for negative.
- Meet het circuitTouch the tip to the contact, wire, fuse, relay, diode or terminal for the test you are running.
- Lees de feedbackUse LED color and buzzer to identify positive, negative, open, continuous, grounded or overloaded conditions.
- Activeer alleen wanneer passendPress “-” for positive output or “=” for negative output; stop at once if the LED changes color with a beep.
Volledige procedures: BT160-gebruikershandleiding (PDF)
Good to Know
Let op
- For 6–24 V DC vehicle systems only. Not for 110 V / 220 V AC household current or any system above 24 V DC.
- Do not inject power or ground into an ECU, SRS, sensor or data line unless a specific procedure allows it; the tester’s protection does not make those circuits safe.
- Sparks can occur at the probe tip. Do not use near combustible gas, dust or explosive atmospheres.
- If overload protection trips, stop and check the circuit, the component and its rated current before continuing.
Onderhoud
- Inspect the case, tip, clips and leads before use; do not use with cracks or exposed wire.
- The probe tip is sharp; store it carefully and away from children.
- Do not disassemble the tester; repairs go to authorized service.
English 
Deutsch 
Español 
Nederlands 
Français 