See Inside Valve Bodies, Chambers and Pipes Without Disassembly
The SVB408 steers a 3.9 mm camera tip in four directions through tight, curved spaces such as transmission valve bodies, combustion chambers, evaporators and fuel lines, and shows the view live on a 4.5-inch IPS screen. The lens is not heat-resistant, so inspect only after the engine has cooled.
- 3.9 mm Probe
- 4-Way 210° Steering
- 8× Digital Zoom
- IP67 Metal Hose
- 80°C Overheat Alarm
Hauptmerkmale
-
Four-Way Articulation
Steer the tip front, back, left and right through 360°, with up to 210° of bending to look around corners.
-
Slim Probe for Narrow Gaps
The small lens enters engine gaps, injection lines and pipes; the 1 m hose turns on a 37 mm minimum radius.
-
Clear, Zoomable Image
1MP imaging with up to 8× digital zoom, from thread detail at close range to cracks deep inside a pipe, over a 25–100 mm depth of field.
-
Even Lighting in the Dark
Six ceramic LEDs with three brightness levels light confined spaces evenly.
-
Built for Wet and Oily Areas
The wear-resistant metal probe hose is rated IP67 for water and oil resistance in wet pipes.
-
Photo and Video Capture
Records still images and video to the built-in memory.
-
Long Sessions per Charge
A 2000 mAh battery runs up to about 180 minutes of continuous use.
More Specifications
| Storage capacity | Over 80,000 images or 40 five-minute videos |
|---|---|
| Menu languages | English, Simplified Chinese, Japanese, Korean, Russian, French, German, Portuguese |
Good to Know
Caution
- Use the camera below 75°C. Right after shutdown an engine is typically 80–100°C or hotter; wait about 1–2 hours for it to cool fully before inspecting.
Care
- Keep the borescope clean, out of prolonged sunlight, and away from direct contact with water, oil and corrosive liquids.
English 
German 
Spanish 