Replacement Targets and Calibration Parts for AUTOOL XC Aligners
Separately sold components for AUTOOL XC503, XC505 and XC508 3D wheel aligners, from a single wheel target to a calibration frame, turntables or a truck clamp set. This listing supplies parts, not a complete aligner.
- XC503 / XC505 / XC508
- 4 Target Positions
- Calibration Frame
- 30″ Truck Clamp Set
Hauptmerkmale
-
Position-Specific Targets
Front-left, front-right, rear-left and rear-right targets are separate options, so a single damaged or missing target can be replaced.
-
Passive Target Design
The XC-series targets are waterproof and drop-resistant, need no regular calibration and have no cables, charging or batteries to fail.
-
Frame, Turntables and Clamps
A calibration frame, turntables and a 30-inch truck wheel clamp set are offered alongside the targets.
How to Choose and Fit
- Identify the alignerThe XC508 has a built-in printer and two displays; the XC505 has a drawer cabinet without a printer; the XC503 has neither drawer nor printer.
- Name the part and positionNote which item is needed and, for targets, which wheel position it serves.
- Match the configurationSelect the variant for the installed model and its current configuration.
- Inspect on arrivalCompare the delivered part with the selected item before installation.
- Verify after fittingRun the geometry, calibration or function check the aligner procedure requires before measuring vehicles.
Good to Know
Caution
- Each component is sold separately; a complete alignment system needs all matched components.
Care
- Keep strong infrared light off the targets and camera area.
- Check clamp contact, target condition and mounting security before every measurement.
English 
German 
Spanish 