Work Up to 1.5 m From the OBD2 Port With a Braided Extension
This cable moves a 16-pin connection 150 cm from a port tucked under the dashboard or in a narrow spot, for AUTOOL Pro3, Launch, ELM327 and similar tools. It is passive: no fault-code reading or protocol conversion of its own.
- 150 cm / 59.05 in
- Nylon Braid Over TPE
- 10.00 mm Cable
- 16-Pin Male to Female
Key Features
-
Long Reach for Awkward Ports
With 1.5 m of cable, the scanner no longer has to hang from a low or recessed socket at an awkward angle.
-
Layered Construction
A flexible TPE jacket sits under a nylon braided sleeve for bending durability, wear resistance and water and aging resistance.
-
Copper Core
Pure copper conductors carry data between the vehicle and the tool.
-
Rated for Repeated Plugging
8 inspection steps from injection to molding; designed for more than 10,000 plugging cycles with proper use.
-
For Shops and Mobile Work
Suited to repair shops, mobile technicians and owners who need easier access during OBD2 testing.
What’s in the Box
- 1×150 cm braided OBD2 16-pin male-to-female extension cable in a package bag
How to Use
- Check the vehicle portIdentify a standard 16-pin OBD2 socket and inspect it for damage.
- Check the toolConfirm the scanner, software and protocol cover the vehicle and task.
- ConnectMale end into the vehicle port, scanner or adapter into the female end, without forcing either.
- Route the full lengthLay the 1.5 m run away from pedals, sharp edges, heat, moving parts and door or trim pinch points.
- Verify communicationRun a read-only check first and compare with a direct connection if anything changes.
Good to Know
Caution
- Keep the cable and tool clear of pedals, steering, seat tracks, doors and driving controls.
- Do not attach unknown or high-current devices to vehicle diagnostic power.
Care
- Hold the connector body to unplug. Avoid pulling on the cable, forcing a damaged socket or bending sharply near the connector.
English 
German 
Spanish 