A 36 cm Braided OBD2 Extension for Easier Scanner Hookup Without Cable Clutter
This mid-length 16-pin male-to-female cable moves the connection a short way out from the vehicle port for Launch Easydiag, THINKDIAG, THINKDRIVER, ELM327 and similar tools, while keeping the cabin tidy. It passes signals through unchanged.
- 36 cm
- Nylon Braided Sleeve
- 10.00 mm Cable
- 16-Pin Male to Female
Key Features
-
Mid-Length Reach
The 360 mm run makes connecting a scanner easier without a long cable taking up space inside the vehicle.
-
Protective Nylon Braid
A braided sleeve over a flexible protective layer adds wear resistance for daily workshop handling. The sleeve is promoted as anti-scalding, waterproof and anti-aging.
-
Copper Core
Pure copper conductors support stable communication between the vehicle and the tool.
-
Inspected for Repeated Use
Automated production with 8 inspection steps from injection to molding; designed for 10,000+ plug-in cycles with proper use.
-
Saves the Vehicle Socket
Leaving the cable in place means fewer direct plug-in cycles on the original OBD2 port.
What’s in the Box
- 1×AUTOOL 36 cm OBD2 male-to-female extension cable
- 1×Product package bag
How to Use
- Confirm the port and pinoutMake sure the vehicle socket is standard 16-pin OBD2 and undamaged.
- Confirm the toolCheck that the scanner and software support the vehicle and the task.
- Male end to vehiclePlug the male connector into the vehicle OBD2 port.
- Female end to toolConnect the diagnostic tool to the female connector.
- Check the connectionRun a read-only check first; if communication is unstable, compare with a direct connection.
Good to Know
Caution
- Match the connector and pin routing to both the vehicle and the tool before connecting.
- Do not power unknown or high-current devices from the diagnostic port.
Care
- Do not bend the cable sharply near the connector or pull it by force; hold the housing to plug and unplug.
- Keep the connector contacts dry and clean.
English 
German 
Spanish 