Charge 24V Forklift and Pallet Jack Batteries Unattended
A 600W automatic charger for 24V lead-acid batteries in forklifts, pallet jacks, floor scrubbers, sightseeing cars and golf carts. It stops on its own when the battery is full or a fault is detected.
- 600W Output
- 15 h Charge Limit
- Anderson Plug
- FCC & ETL
Key Features
-
Readable Status
The display shows 2420 at start-up, then alternates charging voltage (U) and current (R), and reads FULL when charging ends.
-
CC/CV Charging
Constant-current and constant-voltage stages adjust output automatically as the battery fills.
-
Six Fault Codes
No load, battery voltage too low or too high, overheating, short circuit and reverse polarity each show a code and stop charging.
-
Charger Self-Protection
On a reversed or shorted connection the charger isolates itself from the battery, and a 15-hour limit prevents overcharging.
-
Fan Cooling
The fan runs throughout charging, and the unit shuts down if the temperature passes 65°C.
-
Ready to Connect
Comes with a 4 ft power cord, a 3.4 ft charging cable with Anderson plug, a spare plug connector and 2 terminal pins.
More Specifications
| Input frequency | 47–63 Hz |
|---|---|
| Input current | ≤10A |
| Efficiency | 90% |
| Power factor | ≥0.98 |
| Operating temperature | 0 to 45°C |
| Operating humidity | 20–85% |
| Peso | 4.6 lb, with top carry handle |
| Dimensions | 5.11 × 7.59 × 2.75 in |
Good to Know
Caution
- For 24V lead-acid batteries only; it cannot be used as a general power supply.
- After charging, unplug the AC power first, then disconnect the battery connector.
English 
German 
Spanish 