Connectez une prise de diagnostic GM à 12 broches à un outil de diagnostic à 16 broches
This short passive cable links a matching GM 12-pin vehicle socket to a compatible 16-pin OBD2 tool. It only routes the existing signals; diagnostic functions and protocol support still come from the vehicle and the scan tool.
- GM 12 broches vers 16 broches
- Câble de 41 cm
- Âme en cuivre
- Gaine tressée en nylon
- Adaptateur passif
Caractéristiques principales
-
Rallonge courte
The 41 cm length reduces direct pulling on the vehicle diagnostic port while keeping the setup compact.
-
Conducteurs en cuivre
Copper wire carries the data between the vehicle port and the diagnostic equipment.
-
Protection en nylon tressé
The reinforced nylon outer layer adds flexibility and wear resistance for daily use.
-
Léger et compact
At about 125 g, the cable fits easily in a toolbox or diagnostic kit, and the connector body is shaped for quick plug-in.
-
Routage des broches uniquement
L’adaptateur n’ajoute aucune fonction de diagnostic et ne convertit pas les protocoles.
Contenu du coffret
- Câble adaptateur GM de 12 broches vers 16 broches OBD2 AUTOOL
- Emballage protecteur
Mode d’emploi
- Confirmez le port du véhiculeCheck that the vehicle has a compatible GM 12-pin socket; identify the connector, year and pinout, and inspect it for damage.
- Confirmez la combinaison d’outilsVerify the scanner, software, protocol, module, task and any authorization independently of the cable.
- Branchez en toute sécuritéAlignez correctement les connecteurs et ne forcez jamais une fiche incompatible.
- Acheminer sans tensionKeep the cable away from pedals, sharp edges, heat, moving parts and pinched trim.
- Vérifier la communicationRun a read-only connection check first; if communication changes, compare with a direct connection.
Bon à savoir
Attention
- A compatible 16-pin diagnostic scanner and its software are required and sold separately.
- Do not attach unknown or high-current devices to vehicle diagnostic power; follow the vehicle and tool current limits.
- If the tool drops connection, overheats, resets or changes vehicle behavior, stop and return to a known direct connection.
Entretien
- Keep the cable relaxed during testing and avoid sharp bends at the vehicle port.
- Keep the cable away from hot engine parts, belts, fans and sharp metal edges.
FAQ
Ce câble peut-il programmer un module à lui seul ?
No. It contains no diagnostic or programming electronics. Programming depends on a compatible interface, software, authorization, a regulated power setup and the vehicle-specific procedure.
Que dois-je vérifier avant de commander ?
The exact vehicle connector and pinout, model year, scanner hardware, software version, and the module and task you need.
Puis-je le laisser installé pendant la conduite ?
Only when the complete installation is approved for that use and cannot interfere with pedals, steering, trim, seat movement or vehicle networks. For workshop tasks, disconnect it after testing.
English 
Deutsch 
Español 
Nederlands 
Français 