A 4,500 kg Clear-Floor Lift in Standard or Wide Column Spacing
Choose the ATL-4.5D for a standard bay or the ATL-4.5DW for wider column clearance; both use dual-cylinder direct-drive hydraulics with wire-rope synchronization and release both safety locks from one side. A level concrete foundation and adequate ceiling height are required.
- Capacité de 4 500 kg
- Hauteur minimale de 95 mm
- Configuration standard / large
- Double déverrouillage d’un côté
- Bras pour châssis bas
Key Features
-
Pont synchronisé à entraînement direct
Two hydraulic cylinders push directly while a wire-rope balance system keeps both carriages rising evenly, with no lifting chains.
-
Double déverrouillage d’un seul côté
A single control side releases the locks on both columns at once, so the vehicle cannot tilt from one side unlocking while the other stays locked.
-
Verrous de sécurité à crochet
The hook design helps prevent slippage caused by slider wear, and gear-type arm locks hold the support arms in position.
-
Bras pour véhicules bas
Reinforced second and third support arms suit sports cars and ultra-low chassis designs.
-
Hydraulique de précision
Laser-cut steel plates, CNC-machined cylinders with roller-burnished barrels, and Japanese seals for accurate fit and reliable sealing.
-
Résistance à l’usure et à la corrosion
High-molecular wear-resistant sliders reduce friction, and a shot-blasted, high-temperature spray-coated finish resists corrosion.
Autres caractéristiques
| Norme de test EU | Test statique 150%, test dynamique 115% |
|---|---|
| Carriage | Chariot haute résistance de 1.95 m |
| Lift pads | Three-stage screw pads with height extension sleeve |
| Steel plate | Plaque d’acier pleine épaissie de 16 mm |
How to Use
- Vérifiez l’adéquation du siteConfirm the lift drawing, concrete strength and thickness, anchors, ceiling and door clearance, power and approach space.
- Inspectez avant utilisationCheck anchors, columns, arms, pads, hoses, cables, cylinders, locks and synchronization parts.
- Positionner le véhiculeCenter it between the columns with doors, tires and bodywork clear of moving parts.
- Réglez les points de levagePlace arms and pads at the manufacturer’s approved lift points for the actual wheelbase and load.
- Levez et vérifiezLift just enough to take the load, verify all contact points and balance, then continue while watching both sides.
- Verrouillez avant de travaillerLower onto the mechanical locks and confirm both sides are engaged before anyone goes underneath.
- Dégagez et abaissezRemove tools and people, release the locks, lower under control and check the lift after the vehicle exits.
Good to Know
Attention
- Professional installation is recommended: anchoring, leveling, electrical connection, hydraulic setup, balance adjustment and safety checks must be done correctly.
- Confirm workshop ceiling height and overhead clearance against the lift’s overall height before ordering.
- Confirm the voltage option before ordering. Electronic unlocking, where required, may cost extra.
- Infrared, foot, arm or other optional protection is present only if included in the ordered configuration.
- Stop using the lift if hoses, cylinders, cables, seals, anchors or synchronization show damage, leakage or abnormal movement.
English 
Deutsch 
Español 
Nederlands 
Français 