Recover, Evacuate and Recharge R134a Systems From One Station
Preset the job values on the LM707 and it runs recovery, evacuation and recharge in sequence while you monitor the prompts. A built-in filter and separator clean recovered refrigerant for permitted reuse. R134a only; the station does not identify refrigerant.
- R134a Only
- Séquence automatique
- ±10 g Scale
- 2 × flacons d’huile de 350 mL
- 12 kg Internal Tank
Key Features
-
Récupération, tirage au vide et recharge automatiques
Enter the recovery, evacuation and recharge values, then let the station run the steps in order while you check prompts and final results.
-
Quantités de réfrigérant pesées
The built-in electronic scale measures refrigerant weight during recovery and refilling.
-
Nettoyage du réfrigérant récupéré
A filter and separator clean recovered R134a for permitted reuse, and internal circulation purification keeps the stored refrigerant in condition.
-
Séparation de l’huile neuve et usagée
One bottle for new oil and one for used oil keep compressor-oil draining and manual refilling apart.
-
Réservoir de travail intégré
Stores R134a so the station can service several vehicles in a row without changing cylinders.
-
Commandes centralisées
Display, keypad and dedicated pressure gauges keep setup and system readings in one place; the interface is available in six languages.
Autres caractéristiques
| Identification du réfrigérant | Not supported; identify and isolate unknown or contaminated refrigerant before connecting |
|---|---|
| Leak check | Vacuum/pressure-hold check only; does not locate a leak |
| Sélection du port de remplissage | Not available (HP/LP/HP+LP selection is on the LM708 and LM806) |
| Impression des données et base de données | Not available |
Comparaison des modèles
| LM707 | LM708 | LM806 | |
|---|---|---|---|
| Refrigerant | R-134a | HFO-1234yf / R-134a | R-134a |
| Display | 5-inch display | Écran tactile de 7 pouces | Écran tactile de 10.1 pouces |
| Balances électroniques | 1 | 5 | 4 |
| Oil adding | Manual | Automatic | Automatic |
| Oil bottles | 2 × 350 mL | 3 × 350 mL | 3 × 500 mL |
| Tank capacity | 12 kg | 15 kg (remplissage maximal 10 kg) | 18 kg (remplissage maximal 12 kg) |
| Impression, base de données, historiques d’utilisation | No | Oui | Oui |
| Rinçage des conduites | No | No | Oui |
Contenu du coffret
- LM707 main unit with onboard oil bottles and tank
- Flexibles de service rouge et bleu
- Raccords rapides haute et basse pression
- Câble d’alimentation régional
- User manual
How to Use
- Vérifiez le réfrigérant et les données du véhiculeConfirm the vehicle uses R134a and look up the correct refrigerant charge and oil information.
- Inspectez la machine et le réservoirCheck hoses and couplers, oil and pump-oil levels, filter status, tank safety and working refrigerant quantity.
- Brancher moteur arrêtéAttach the high- and low-side couplers securely and keep hoses clear of heat and moving parts.
- Preset and runEnter the recovery, evacuation and recharge values, then monitor the automatic sequence.
- Vérifier et débrancherReview recovered and charged amounts, pressures and A/C operation, then close and disconnect safely.
Setup, oil handling, filter service and troubleshooting: Manuel d’utilisation LM707 (PDF).
Good to Know
Attention
- Never connect the LM707 to HFO-1234yf, mixed, unidentified or any other refrigerant.
- Never fill the internal tank above 80% of its capacity; the margin guards against extra pressure from external factors.
- Keep at least 3 kg of refrigerant in the tank, or recharging may not be possible.
- Start recovery no more than 10 times per hour; frequent starts can damage the compressor.
- Do not use compressed air to pressure- or leak-test the station or the vehicle A/C circuit.
- Use grounded power that matches the unit nameplate, and keep the station away from open flames and hot objects.
Entretien
- Replace the filter after 100 kg of recovered refrigerant, following the device prompt.
- Service the vacuum-pump oil when the 600-minute reminder appears, or sooner if it turns cloudy or contaminated.
- Run circulation purification about once a month.
- Add compressor oil according to the amount discharged; avoid overfilling.
- Do not modify the pressure-reducing valve or system settings.
English 
Deutsch 
Español 
Nederlands 
Français 